Wlan Add/Edit: Wpa-Psk/Wpa2-Psk Security - ZyXEL Communications ZYWALL USG 20 Manual

The following table describes the WEP-related wireless LAN security labels. See
Table 60 on page 254
Table 61 Configuration > Network > Interface > WLAN > Add (WEP Security)
LABEL
WEP
Encryption
Key 1 to Key 4 If you chose 64-bit WEP in the WEP Encryption field, then enter any 5

11.6.3 WLAN Add/Edit: WPA-PSK/WPA2-PSK Security

WPA-PSK or WPA2-PSK security has all of the WLAN interface's users share the
same password (pre-shared key).
To configure and enable WPA-PSK or WPA2-PSK security, click Configuration >
Network > Interface > WLAN > Add (or Edit) to open the WLAN Edit screen.
Select WPA-PSK, WPA2-PSK, or WPA/WPA2-PSK as the Security Type.
WPA/WPA2-PSK means wireless clients can use either WPA-PSK or WPA2-PSK
to connect to the WLAN interface. The following screen shows the security fields.
Figure 171 Configuration > Network > Interface > WLAN > Add (WPA-PSK, WPA2-
PSK, or WPA/WPA2-PSK Security)
ZyWALL USG 20/20W User's Guide
for information on the 802.1x fields.
DESCRIPTION
WEP (Wired Equivalent Privacy) provides data encryption to prevent
unauthorized wireless stations from accessing data transmitted over the
wireless network.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
characters (ASCII string) or 5 pairs of hexadecimal characters ("0-9", "A-
F") preceded by 0x for each key.
If you chose 128-bit WEP in the WEP Encryption field, then enter 13
characters (ASCII string) or 13 pairs of hexadecimal characters ("0-9",
"A-F") preceded by 0x for each key.
There are four data encryption keys to secure your data from
eavesdropping by unauthorized wireless users. The values for the keys
must be set up exactly the same on the access points as they are on the
wireless stations.
Chapter 11 Interfaces
259