Endpoint Security Screen - ZyXEL Communications ZYWALL USG 20 Manual

42.2 Endpoint Security Screen

The Endpoint Security screen displays the endpoint security objects you have
configured on the ZyWALL.
Click Configuration > Object > Endpoint Security to display the screen.
Figure 365 Configuration > Object > Endpoint Security
The following table gives an overview of the objects you can configure.
Table 188 Configuration > Object > Endpoint Security
LABEL
Add
Edit
Remove
Object
References
Object Name
Description
Endpoint
Operating
System
Checking
Failure
Message
ZyWALL USG 20/20W User's Guide
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen where
you can modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms you
want to remove it before doing so.
Select an entry and click Object References to open a screen that shows
which settings use the object. See
example.
This field displays the descriptive name that identifies this object.
If the entry has a description configured, it displays here.
This is the type of operating system that the user's computer must be
using.
Enter a message to display when a user's computer fails the endpoint
security check. Use up to 1023 characters (0-9a-zA-Z;/?:@=+$\.-
_!*'()%,"). For example, "Endpoint Security checking failed. Please
contact your network administrator for help.".
Chapter 42 Endpoint Security
Section 11.3.2 on page 232 for an
623