ZyXEL Communications ZYWALL USG 20 Manual page 649

Table 200 Configuration > System > WWW > Service Control (continued)
LABEL
HTTP
Enable
Server Port
Admin/User
Service Control
Add
Edit
Remove
Move
#
Zone
Address
Action
Authentication
Client
Authentication
Method
ZyWALL USG 20/20W User's Guide
DESCRIPTION
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control
table to access the ZyWALL Web Configurator using HTTP
connections.
You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service to access the ZyWALL.
Admin Service Control specifies from which zones an administrator
can use HTTP to manage the ZyWALL (using the Web Configurator).
You can also specify the IP addresses from which the administrators
can manage the ZyWALL.
User Service Control specifies from which zones a user can use
HTTP to log into the ZyWALL (to log into SSL VPN for example). You
can also specify the IP addresses from which the users can access
the ZyWALL.
Click this to create a new entry. Select an entry and click Add to
create a new entry after the selected entry.
Double-click an entry or select it and click Edit to be able to modify
the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL
confirms you want to remove it before doing so. Note that
subsequent entries move up by one when you take this action.
To change an entry's position in the numbered list, select the method
and click Move to display a field to type a number for where you
want to put it and press [ENTER] to move the rule to the number
that you typed.
This is the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL's
(non-configurable) default policy. The ZyWALL applies this to traffic
that does not match any other configured rule. It is not an editable
rule. To apply other behavior, configure a rule that traffic will match
so the ZyWALL will not have to use the default policy.
This is the zone on the ZyWALL the user is allowed or denied to
access.
This is the object name of the IP address(es) with which the
computer is allowed or denied to access.
This displays whether the computer with the IP address specified
above can access the ZyWALL zone(s) configured in the Zone field
(Accept) or not (Deny).
Select a method the HTTPS or HTTP server uses to authenticate a
client.
You must have configured the authentication methods in the Auth.
method screen.
Chapter 43 System
649