Editing Ppp Options; Figure 90 Menu 11.2 Remote Node Ppp Options; Table 66 Menu 11.2 Remote Node Ppp Options - ZyXEL Communications P-202H V2 User Manual

P-202H Plus v2 User's Guide
If, after making the call to bring up a second channel, the second channel does not succeed in
joining the Multilink Protocol bundle (because the remote device does not recognize the
second call as coming from the same device), the ZyXEL Device will hang up the second call
and continue with the first channel alone.

20.6 Editing PPP Options

To edit the remote node PPP options, move the cursor to the Edit PPP Options field in Menu
11.1 - Remote Node Profile, and use [SPACE BAR] to select Yes. Press [ENTER] to open
menu 11.2, as shown next.

Figure 90 Menu 11.2 Remote Node PPP Options

The following table describes the fields in this menu.

Table 66 Menu 11.2 Remote Node PPP Options

FIELD
Encapsulation
Compression
BACP
Multiple Link Options:
BOD Calculation
Base Trans Rate
(Kbps)
191
Menu 11.2 - Remote Node PPP Options
Encapsulation= Standard PPP
Compression= No
BACP= Enable
Multiple Link Options:
BOD Calculation= Transmit or Receive
Base Trans Rate(Kbps)= 64
Max Trans Rate(Kbps)= 64
Target Utility(Kbps)= 32-48
Add Persist(sec)= 5
Subtract Persist(sec)= 5
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Select CISCO PPP only when this remote node is a Cisco machine; otherwise,
select Standard PPP.
Turn on/off Stac Compression. The default for this field is No.
Your ZyXEL Device negotiates the secondary phone number for a dial-up line from
the peer when BACP (Bandwidth Allocation Control Protocol) is enabled;
otherwise it uses the secondary phone number set in menu 11.1.
Select the direction of the traffic you wish to use in determining when to add or
subtract a link. Options for this field are: Transmit or Receive, Transmit and
Receive.
Select the base data transfer rate for this remote node in Kbps. There are two
choices for this field: 64 where only one channel is used or, 128 where two
channels are used as soon as a packet triggers a call.
Chapter 20 Remote Node Configuration