Table of Contents
Advertisement
Session Options:
Edit Filter Sets
4.1.1 Editing PPP Options
Press Space Bar to Toggle.
FIELD
Encapsulation
Compression
Once you have completed Menu 11.2
"Press ENTER to Confirm . . . to confirm your selections or press ESC to cancel your selections".
4.2
Editing TCP/IP Options
Move the cursor to the Edit IP field in Menu 11.1, then press the [space bar] to toggle and set the value to
Yes. Press the [Enter]
This section shows you how to configure your Prestige for TCP/IP. Depending on your particular
applications, you need to configure different menus. For instance, Internet access is the most common
application of TCP/IP. For this application, you should configure Menu 4. Configuration for other
applications is shown in the following sections.
Remote Node Setup
In these fields, select which filter set(s) you would like to
implement to filter the incoming and outgoing traffic between this
Remote Node and your Prestige. You can choose from 12
different filter sets. In addition, you can link up to 4 filter sets
together for further customization (e.g., 1, 5, 9, 12). Note that
spaces and "," are accepted in this field.
For more information on customizing your filter sets, see Chapter
6. The default is blank, i.e., no filters defined.
Menu 11.2 - Remote Node PPP Options
Encapsulation = Standard PPP
Compression = No
Press ENTER to Confirm or ESC to Cancel:
Figure 4-2
Menu 11.2 Remote Node PPP Options
Table 4-2
Fields in Menu 11.2 (PPP Options )
Select CCP (Compression Control Protocol) for the PPP
or MP link. There are two options in this field:
Standard PPP – Standard PPP options is used.
CISCO PPP – CISCO PPP options is used.
Turns on Stac Compression. The default for this field is
Off.
– Remote Node PPP Options, press the [Enter] key at the message
to open Menu 11.3 – Remote Node Network Layer Options.
key
DESCRIPTION
Prestige 100L IDSL Router
No/Yes
EXAMPLES
Standard
PPP / CISCO
PPP
No/Yes
4-3
Advertisement
Table of Contents
Troubleshooting
