Remote Node Filter - ZyXEL Communications P-202H V2 User Manual

P-202H Plus v2 User's Guide
Table 68 Menu 11.3 Remote Node Network Layer Options
FIELD
My WAN Addr
NAT
Address Mapping
Set
Metric
Private
RIP Direction
Version
Once you have configured this menu, press [ENTER] at the message "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.

20.9 Remote Node Filter

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to
set the value to Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between
this remote node and the ZyXEL Device to prevent certain packets from triggering calls. You
can specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. For more information on defining the filters, please
refer to the Filters chapter. For PPPoE or PPTP encapsulation, you have the additional option
of specifying remote node call filter sets.
195
DESCRIPTION
Some implementations, especially the UNIX derivatives, require the ISDN link to
have a separate IP network number from the LAN and each end must have a
unique address within the WAN network number. If this is the case, enter the IP
address assigned to the ISDN port of your ZyXEL Device.
Note: This is the address assigned to your local ZyXEL Device
WAN, not the remote router. If the remote router is a ZyXEL
Device, then this entry determines the local ZyXEL Device
Rem IP Addr in menu 11.1.
Choose from None, Full Feature, or SUA Only. When you select Full Feature,
you must configure at least one address mapping set.
For more information about NAT and the choices listed refer to the NAT Chapter.
A NAT address mapping set is to create the mapping table used to assign global
addresses to computers on the LAN. You may enter any address mapping set
number up to 8. Set 255 (read only) is used for SUA.
Metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
This parameter determines if the ZyXEL Device will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept private and not
included in RIP broadcast. If No, the route to this remote node will be propagated
to other hosts through RIP broadcasts.
Press [SPACE BAR] and then [ENTER] to select from Both, In Only, Out Only
and None.
Press [SPACE BAR] and then [ENTER] to select the RIP version from RIP-1, RIP-
2B and RIP-2M.
Chapter 20 Remote Node Configuration