Figure 92 Menu 11.3 Remote Node Network Layer Options; Table 67 Tcp/Ip-Related Fields In Remote Node Profile; Table 68 Menu 11.3 Remote Node Network Layer Options; Rem Ip Addr - ZyXEL Communications P-202H V2 User Manual

1 To configure the TCP/IP parameters of a remote node, first configure the three fields in
Menu 11.1 - Remote Node Profile, as shown in the following table.

Table 67 TCP/IP-related Fields in Remote Node Profile

Rem IP Addr

Edit IP
2 Move the cursor to the Edit IP field in Menu 11 - Remote Node Profile, and then press
[SPACE BAR] to toggle and set the value to Yes. Press [ENTER] to open Menu 11.3 -
Remote Node Network Layer Options.

Figure 92 Menu 11.3 Remote Node Network Layer Options

The following table describes the fields in this menu.

Table 68 Menu 11.3 Remote Node Network Layer Options

FIELD
Rem IP Addr
Rem Subnet Mask Enter the subnet mask for the remote network.
Chapter 20 Remote Node Configuration
Enter the IP address of the remote gateway in Menu 11.1 - Remote Node Profile.
You must fill in either the remote ZyXEL Device WAN IP address or the remote
ZyXEL Device LAN IP address. This depends on the remote router's WAN IP i.e.,
for the (remote) ZyXEL Device, the My WAN IP Addr settings in Menu 4. For
example, if the remote WAN IP is set to 172.16.0.2 (the remote router's WAN IP),
then you should enter 172.16.0.2 in the Rem IP Add field. If the remote WAN IP is
0.0.0.0, then enter 192.168.1.1(the remote router's LAN IP) in the Rem IP Addr
field).
Press [SPACE BAR] and then [ENTER] to select Yes and press [ENTER] to go to
Menu 11.3 - Remote Node Network Layer Options.
Menu 11.3 - Remote Node Network Layer Options
Rem IP Addr: 0.0.0.0 (r.o.)
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
This will show the IP address you entered for this remote node in the previous
menu.
P-202H Plus v2 User's Guide
194