Outgoing Authentication Protocol - ZyXEL Communications P-202H V2 User Manual

P-202H Plus v2 User's Guide
Table 64 Menu 11.1 Remote Node Profile
FIELD
Rem IP Addr
Edit IP
Telco Options:
Transfer Type
Allocated Budget
(min)
Period (hr)
Schedules
Carrier Access
Code
Nailed-up
Connection
Toll Period
Session Options
Edit Filter Sets
Idle Timeout (sec)
Once you have configured this menu, press [ENTER] at the message "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.

20.3 Outgoing Authentication Protocol

Generally speaking, you should employ the strongest authentication protocol possible, for
obvious reasons. However, some vendor's implementation includes a specific authentication
protocol in the user profile. It will disconnect if the negotiated protocol is different from that in
the user profile, even when the negotiated protocol is stronger than specified. If you encounter
a case where the peer disconnects right after a successful authentication, please make sure that
you specify the correct authentication protocol when connecting to such an implementation.
189
DESCRIPTION
This is a required field [?]. Enter the IP address of the remote gateway.
This field leads to a "hidden" menu. Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.3 - Remote Node Network Layer Options.
This field specifies the type of connection between the ZyXEL Device and this
remote node. When set to Leased, the Allocated Budget and Period do not
apply.
This field sets a ceiling for outgoing call time for this remote node. The default for
this field is 0 for no budget control.
This field sets the time interval to reset the above outgoing call budget control.
Apply up to 4 schedule sets, separated by commas to your remote node here.
Please see ahead for a full discussion on schedules.
In some European countries, you need to enter the access code number of your
preferred telecommunications service provider. Your telephone company should
supply you with this number.
This field specifies if you want to make the connection to this remote node a
nailed-up connection. See the following section for more details.
This is the basic unit of time for charging purposes, e.g., 25 cents every 3 minutes
- 3 minutes is the Toll Period.
This field leads to another "hidden" menu. Use [SPACE BAR] to select Yes and
press [ENTER] to open menu 11.5 to edit the filter sets. See the Remote Node
Filter section for more details.
This value specifies the number of idle seconds that elapses before the remote
node is automatically disconnected. Idle seconds is the period of time when no
data is transmitted from your ZyXEL Device. Administrative packets such as RIP
are not counted as data. The default is 300 seconds (5 minutes). Idle timeout only
applies when the ZyXEL Device initiates the call. 0 sec means the remote node
will never be automatically disconnected.
Chapter 20 Remote Node Configuration