Chapter 30 System Maintenance; Command Interpreter Mode; Command Syntax; Figure 189 Command Mode In Menu 24 - ZyXEL Communications P-202H V2 User Manual

This chapter leads you through SMT menus 24.8 to 24.10.

30.1 Command Interpreter Mode

The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of
the same functionality as the SMT, while adding some low-level setup and diagnostic
functions. Enter the CI from the SMT by selecting menu 24.8. See the included disk or the
zyxel.com web site for more detailed information on CI commands. Enter 8 from Menu 24 —
System Maintenance. A list of valid commands can be found by typing help or ? at the
command prompt. Type "exit" to return to the SMT main menu when finished.

Figure 189 Command Mode in Menu 24

30.1.1 Command Syntax

• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means "or".
• For example,
• sys filter netbios config <type> <on|off>
• means that you must specify the type of netbios filter and whether to turn it on or off.

Chapter 30 System Maintenance

C
System Maintenance
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Firmware Update
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:
P-202H Plus v2 User's Guide
H A P T E R
3 0
284