Table 66 Menu 11.2 Remote Node PPP Options
FIELD
Max Trans Rate
(Kbps)
Target Utility
(Kbps)
Add Persist
Subtract Persist
Once you have configured this menu, press [ENTER] at the message "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
20.7 LAN-to-LAN Application
A typical LAN-to-LAN application is to use your ZyXEL Device to connect a branch office to
the headquarters, as depicted in the following diagram.
Figure 91 TCP/IP LAN-to-LAN Application
For the branch office, you need to configure a remote node in order to dial out to headquarters.
Chapter 20 Remote Node Configuration
DESCRIPTION
Enter the maximum data transfer rate allowed for this remote node. This
parameter is in kilobits per second.
Enter the two thresholds separated by a "-" for subtracting and adding the second
port.
This parameter specifies the number of seconds where traffic is above the adding
threshold before the ZyXEL Device will bring up the second link.
This parameter specifies the number of seconds where traffic is below the
subtraction threshold before your ZyXEL Device drops the second link.
P-202H Plus v2 User's Guide
192