Using The Ftp Command From The Command Line; Example Of Ftp Commands From The Command Line; Figure 169 Telnet In Menu 24.5; Figure 170 Ftp Session Example - ZyXEL Communications P-202H V2 User Manual

Figure 169 Telnet in Menu 24.5

To transfer the configuration file to your workstation, follow the procedure
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current router configuration to
your workstation.
For details on FTP commands, please consult the documentation of your FTP
client program.
in this menu to back up using TFTP), please see your router manual.
Press ENTER to Exit:

29.2.2 Using the FTP Command from the Command Line

1 Launch the FTP client on your computer.
2 Enter "open", followed by a space and the IP address of your ZyXEL Device.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter "bin" to set transfer mode to binary.
6 Use "get" to transfer files from the ZyXEL Device to the computer, for example, "get
rom-0 config.rom" transfers the configuration file on the ZyXEL Device to your
computer and renames it "config.rom". See earlier in this chapter for more information on
filename conventions.
7 Enter "quit" to exit the ftp prompt.

29.2.3 Example of FTP Commands from the Command Line

Figure 170 FTP Session Example

Chapter 29 Firmware and Configuration File Maintenance
Menu 24.5 - Backup Configuration
For details on backup using TFTP (note that you must remain
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
P-202H Plus v2 User's Guide
272