Table 82 Menu 22 Snmp Configuration; Table 83 Snmp Traps; Table 84 Ports And Permanent Virtual Circuits - ZyXEL Communications P-202H V2 User Manual

The following table describes the SNMP configuration parameters.

Table 82 Menu 22 SNMP Configuration

FIELD
SNMP:
Get Community
Set Community
Trusted Host
Trap:
Community
Destination
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
26.4 SNMP Traps
The ZyXEL Device will send traps to the SNMP manager when any one of the following
events occurs:

Table 83 SNMP Traps

TRAP #
1
2
3
4
6
The port number is its interface index under the interface group.

Table 84 Ports and Permanent Virtual Circuits

PVC (PERMANENT
PORT
VIRTUAL CIRCUIT)
1 Ethernet LAN
2 1
3 2
Chapter 26 SNMP Configuration
DESCRIPTION
Type the Get Community, which is the password for the incoming Get- and
GetNext requests from the management station.
Type the Set Community, which is the password for incoming Set requests from
the management station.
If you enter a trusted host, your ZyXEL Device will only respond to SNMP
messages from this address. A blank (default) field means your ZyXEL Device will
respond to all SNMP messages it receives, regardless of source.
Type the trap community, which is the password sent with each trap to the SNMP
manager.
Type the IP address of the station to send your SNMP traps to.
TRAP NAME
coldStart (defined in RFC-1215)
warmStart (defined in RFC-1215)
linkUp (defined in RFC-1215)
authenticationFailure (defined in
RFC-1215)
linkDown (defined in RFC-1215)
P-202H Plus v2 User's Guide
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent with the port number.
A trap is sent to the manager when receiving any
SNMP get or set requirements with wrong
community (password).
A trap is sent with the port number when any of the
links are down. See the following table.
252