Restore Configuration; Restore Using Ftp; Figure 174 Successful Backup Confirmation Screen; Figure 175 Telnet Into Menu 24.6 - ZyXEL Communications P-202H V2 User Manual

Figure 174 Successful Backup Confirmation Screen

29.3 Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your ZyXEL
Device since FTP is faster. Please note that you must wait for the system to automatically
restart after the file transfer is complete.
Note: WARNING! Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR ZyXEL Device.

29.3.1 Restore Using FTP

For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter

Figure 175 Telnet into Menu 24.6.

To transfer the firmware and the configuration file, follow the procedure
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router.
SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-spt is the
remote file name on the router. This restores the configuration to
your router.
4. The system reboots automatically after a successful file transfer.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on restoring using TFTP (note that you must
remain on this menu to restore using TFTP), please see your router
manual.
Press ENTER to Exit:
1 Launch the FTP client on your computer.
2 Enter "open", followed by a space and the IP address of your ZyXEL Device.
Chapter 29 Firmware and Configuration File Maintenance
** Backup Configuration completed. OK.
### Hit any key to continue.###
Menu 24.6 - Restore Configuration
P-202H Plus v2 User's Guide
Then type "root" and
276