ZyXEL Communications P-202H V2 User Manual page 205

Table 71 Menu 13 Default Dial-in Setup
FIELD
Compression
Mutual Authen
O/G Username
O/G Password
Multiple Link
Options:
Max Trans
Rate(Kbps)
Callback Budget
Management:
Allocated Budget
(min)
Period (hr)
IP Address
Supplied By:
Dial-in User
IP Pool
IP Start Addr
IP Count (1, 4)
Session Options:
Chapter 22 Dial-in Setup
DESCRIPTION
Turn on/off Stac Compression. The default for this field is No.
Some vendors, e.g., Cisco, require mutual authentication, i.e., the node that
initiates the call will request a user name and password from the far end that it is
dialing to. If the remote node requires mutual authentication, set this field to Yes.
Enter the login name to be used to respond to the peer's authentication request.
Enter the outgoing password to be used to respond to the peer's authentication
request.
Enter the maximum data transfer rate between your ZyXEL Device and the remote
dial-in user.
64 - At most, one B channel is used.
128 - A maximum of two channels can be used. When the ZyXEL Device calls
back to the remote dial-in user, the maximum data transfer rate is always 64.
This field sets the budget callback time for all the remote dial-in users. The default
for this field is 0 for no budget control.
This field sets the time interval to reset the above callback budget control.
If set to Yes, the ZyXEL Device will allow a remote host to specify its own IP
address.
If set to No, the remote host must use the IP address assigned by your ZyXEL
Device from the IP pool, configured below. This is to prevent the remote host from
using an invalid IP address and potentially disrupting the whole network.
This field tells your ZyXEL Device to provide the remote host with an IP address
from the pool. This field is required if Dial-In IP Address Supplied By: Dial-in
User is set to No. You can configure this field even if Dial-in User is set to Yes, in
which case your ZyXEL Device will accept the IP address if the remote peer
specifies one; otherwise, an IP address is assigned from the pool.
This field is applicable only if you selected Yes in the Dial-In IP Address
Supplied By: IP Pool field.
The IP pool contains contiguous IP addresses and this field specifies the first one
in the pool. The IP start address is the start of a series of consecutive IP
addresses.
In this field, enter the number (1 to 4) of addresses in the IP pool. For example, if
the starting address is 192.168.135.5 and the count is 2, then the pool will have
192.68.135.5 and 192.68.135.6. The IP count is the number of consecutive IP
addresses allowed.
P-202H Plus v2 User's Guide
204