Setting Up Default Dial-In; Figure 97 Menu 13 Default Dial-In Setup; Table 71 Menu 13 Default Dial-In Setup; Allocated Budget(Min) - ZyXEL Communications P-202H V2 User Manual

P-202H Plus v2 User's Guide

22.3 Setting Up Default Dial-in

From the Main Menu, enter 13 to go to Menu 13 - Default Dial-in Setup. This section
describes how to configure the protocol-independent fields in this menu. For the protocol-
dependent fields, refer to the appropriate chapters.

Figure 97 Menu 13 Default Dial-in Setup

Telco Options:
CLID Authen= None
PPP Options:
Recv Authen= CHAP/PAP
Compression= Yes
Mutual Authen= No
O/G Username=
O/G Password= ********
Multiple Link Options:
Max Trans Rate(Kbps)= 128
Callback Budget Management:

Allocated Budget(min)=

Period(hr)=

The following table describes the fields in this menu.

Table 71 Menu 13 Default Dial-in Setup

FIELD
Telco Options:
CLID Authen
PPP Options:
Recv Authen
203
Menu 13 - Default Dial-in Setup
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
This field sets the CLID authentication parameter for all incoming calls. There are
three options for this field:
None - No CLID is required.
Required - CLID must be available, or the ZyXEL Device will not answer the call.
Preferred - If the CLID is available then CLID will be used; otherwise,
authentication is performed in PPP negotiation.
This field sets the authentication protocol for incoming calls. For security reason,
setting authentication to None is strongly discouraged. Options for this field are:
CHAP/PAP - Your ZyXEL Device will try CHAP first, but PAP will be used if CHAP
is not available.
CHAP -Use CHAP only.
PAP - Use PAP only.
None - Your ZyXEL Device tries to acquire CHAP/PAP first, but no authentication
is required if CHAP/PAP is not available.
IP Address Supplied By:
Dial-in User= Yes
IP Pool= No
IP Start Addr= N/A
IP Count(1,4)= N/A
Session Options:

Edit Filter Sets= No

Chapter 22 Dial-in Setup