Procedure To Configure Dynamic Dns; Figure 76 Menu 1.1 Configure Dynamic Dns; Table 55 Menu 1 General Setup - ZyXEL Communications P-202H V2 User Manual

P-202H Plus v2 User's Guide
2 Fill in the required fields. Refer to the table shown next for more information about these
fields.

Table 55 Menu 1 General Setup

FIELD
System Name
Location
Contact Person's
Name
Domain Name
Edit Dynamic DNS
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.

16.2.1 Procedure to Configure Dynamic DNS

Note: If you have a private WAN IP address, then you cannot use Dynamic DNS.
To configure Dynamic DNS, go to Menu 1 - General Setup and select Yes in the Edit
Dynamic DNS field. Press [ENTER] to display Menu 1.1 - Configure Dynamic DNS as
shown next.

Figure 76 Menu 1.1 Configure Dynamic DNS

167
DESCRIPTION
Choose a descriptive name for identification purposes. It is recommended you
enter your computer's "Computer name" in this field. This name can be up to 30
alphanumeric characters long. Spaces are not allowed, but dashes "-" and
underscores "_" are accepted.
Enter the geographic location (up to 31 characters) of your ZyXEL Device.
Enter the name (up to 30 characters) of the person in charge of this ZyXEL
Device.
Enter the domain name (if you know it) here. If you leave this field blank, the ISP
may assign a domain name via DHCP. You can go to menu 24.8 and type "sys
domainname" to see the current domain name used by your router.
The domain name entered by you is given priority over the ISP assigned domain
name. If you want to clear this field just press [SPACE BAR] and then [ENTER].
Press [SPACE BAR] and then [ENTER] to select Yes or No (default). Select Yes
to configure Menu 1.1: Configure Dynamic DNS discussed next.
Menu 1.1 - Configure Dynamic DNS
Service Provider= WWW.DynDNS.ORG
Active= No
Host=
EMAIL=
USER=
Password= ********
Enable Wildcard= No
Press ENTER to Confirm or ESC to Cancel:
Chapter 16 Menu 1 General Setup