Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 87

Chapter 3 Connecting Ethernet, Fast Ethernet, and Token Ring Network Modules
Figure 3-20 1-Ethernet 1-Token Ring 2-WAN Card Slot Network Module
1E
1R W1
Figure 3-21 1-Fast Ethernet 1-Token Ring 2-WAN Card Slot Network Module
1FE
1R2W
Connecting Token Ring Ports
The 1-Ethernet 1-Token Ring 2-WAN card slot network module and the 1-Fast Ethernet 1-Token Ring
2-WAN card slot network module each have one DB-9 connector for an STP Token Ring connection and
one RJ-45 connector for a UTP Token Ring connection. Only one connector can be active at a time.
To connect the module to a Token Ring network, attach one end of a shielded Token Ring lobe cable to
the DB-9 connector on the network module (see
Ring lobe cable to the UTP connector on the network module (see
the cable to the Token Ring media attachment unit (MAU). The network module automatically detects
which connector is in use.
OL-2485-20
Token Ring
interface LEDs
STP
TOKEN RING 0
STP port UTP port
STP port UTP port
W1
TOKEN RING 0
10BASE-T
port
ETHERNET 0
Ethernet
LEDs
100BASE-T
port
FAST ETH 0
LEDs LEDs
Figure 3-22), or attach one end of an unshielded Token
Cisco Network Modules Hardware Installation Guide
Token Ring Network Modules
WO
AUI port
AUI
EN
W0
EN
Enable
LED
Figure 3-23). Attach the other end of
3-11