Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 56

Installing Cisco Network Modules in Cisco Access Routers
Install the blank faceplate.
Step 2
•
•
Continue with hardware installation tasks.
Step 3
Removing Blank Faceplates from Cisco Access Routers
To remove blank network module faceplates, perform the following steps:
Determine which type of blank network module faceplate you are using. (See
Step 1
Figure
Remove the blank faceplate.
Step 2
•
•
Save blank faceplates for future use.
Tip
Step 3 Continue with hardware installation tasks.
Preparing Cisco Router Slots for Network Module Installation
Several Cisco access routers have flexible network module slots to support all four Cisco network
module form factors. Before installing a network module, you must prepare the slot for the network
module's particular form factor.
The following Cisco access routers may require network module slot preparation before installation of
the network module:
•
•
•
•
For an introduction to Cisco network module form factors, see the
Tip
Module Form Factors" section on page
Cisco Network Modules Hardware Installation Guide
2-8
(For blank faceplates with mounting screws) Align the captive screws with the screw holes on the
chassis. Using either a number 1 Phillips screwdriver or a small flat-blade screwdriver, tighten the
captive screws until the blank faceplate is flush with the chassis.
(For blank faceplates with tabs) Align the blank faceplate tabs with the slots on the chassis. Press
the blank faceplate against the chassis until the tabs pop into place. The blank faceplate is flush with
the chassis when properly installed.
2-2.)
(For blank faceplates with mounting screws) Using either a number 1 Phillips screwdriver or a small
flat-blade screwdriver, unscrew the captive screws and remove the blank faceplate from the chassis
slot you plan to use.
(For blank faceplates with tabs) Using a small flat-blade screwdriver, release the snap-lock tab on
the left side of the faceplate (see
Cisco 2821 and 2851 routers
Cisco 3660 routers (single-wide and double-wide network modules only)
Cisco 3700 series routers (single-wide and double-wide network modules only)
Cisco 3800 series routers
Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
Figure 2-2). The faceplate pops out when the tab is released.
1-1.
Figure 2-1 and
"Introduction to Cisco Network
OL-2485-20