Interfaces Supported - Cisco CISCO2650 - 2650 Router Hardware Installation Manual

Interfaces Supported

Interfaces Supported
The compression network module supports the following interfaces:
•
•
•
•
•
Compression Network Module LEDs
Figure 14-2
Figure 14-2 Compression Network Module LEDs
COMPRESSION
Table 14-1 Compression Network Module LEDs
LED
EN
ERROR
ACTIVE
Cisco Network Modules Hardware Installation Guide
14-2
Channelized T1 Integrated Services Digital Network (ISDN) Primary Rate Interface (PRI)
Channelized E1 ISDN PRI
ISDN Basic Rate Interface (BRI)
Synchronous serial
Switched 56-kbps data service unit/channel service unit (DSU/CSU)
shows compression network module LEDs.
Meaning
Green indicates that the module has passed its self-tests and is available to the router.
Amber indicates that an error was found, and if the LED remains on, that the error might
prevent accurate compression.
Off during normal operation.
Green indicates that the module is ready to process data. It comes on when the boot
process is complete and stays on during normal operation.
Chapter 14 Connecting Compression Network Modules
Table 14-1 describes their meaning.
EN
Error LED Enable LED
Active LED
OL-2485-20