Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 182

ATM OC-3 Network Modules
ports) in the ATM OC-3/STM-1 circuit emulation service network module. If a multiflex trunk interface
card is not installed, the ATM OC-3/STM-1 circuit emulation service network module continues to
perform data-routing functions.
To install a multiflex trunk interface card in a network module, see the Cisco Interface Cards Hardware
Installation Guide. To obtain this publication, see the
1- or 2-port T1 or E1 multiflex trunk interface cards that support G.703 (VWIC-1MFT-G703,
Note
VWIC-2MFT-G703) are not supported in ATM OC-3/STM-1 circuit emulation service network
modules.
Figure 11-7 ATM OC-3 Multimode Fiber Network Module
ATM
1A-OC3MM
Figure 11-8 ATM OC-3 Single-Mode Intermediate-Reach Fiber Network Module
ATM
1A-OC3SMI
Figure 11-9 ATM OC-3 Single-Mode Long-Reach Fiber Network Module
ATM
1A-OC3SML
Figure 11-10 ATM OC-3/STM-1 Circuit Emulation Service Multimode Fiber Network Module
ATM
1A-OC3
MM-1V
CES
Cisco Network Modules Hardware Installation Guide
11-6
Chapter 11
"Obtaining Documentation" section on page
CLASS 1 LASER PRODUCT PRODUCT LASER DE CLASSE1
LASERPRODUCT DER KLASSE 1 PRODUCTO LASER CLASE 1
ATM 0
RCLK FERF OOF AIS
CLASS 1 LASER PRODUCT PRODUCT LASER DE CLASSE1
LASERPRODUCT DER KLASSE 1 PRODUCTO LASER CLASE 1
ATM 0
RCLK FERF OOF AIS
CLASS 1 LASER PRODUCT PRODUCT LASER DE CLASSE1
LASERPRODUCT DER KLASSE 1 PRODUCTO LASER CLASE 1
ATM 0
RCLK FERF OOF AIS
ATM 0
TX
FERF OOF AIS
VO
Connecting ATM Network Modules
EN
EN
EN
RX
EN
RCLK
viii.
OL-2485-20