Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 394

Online Insertion and Removal of Cisco Network Modules Procedure
Destination filename? filename
Note
Exit the network module session by pressing Control-Shift-6, followed by pressing x.
Step 3
On the router, clear the integrated-Service-Engine console session by using the following command:
Step 4
Router# service-module integrated-Service-Engine slot / unit session clear
Step 5 Perform a graceful shutdown of the network module disk drive by using the following command:
Router# service-module integrated-Service-Engine slot / unit shutdown
Shut down the network module interface:
Step 6
Router (config)# interface integrated-Service-Engine slot/unit
Router (config-if)# shutdown
Router (config-if)# exit
Loosen the two captive screws that are holding the network module in the chassis slot.
Step 7
Slide the network module out of the slot.
Step 8
Align the replacement network module with the guides in the chassis slot, and slide it gently into the slot.
Step 9
Note
Step 10 Push the module into place until you feel its edge connector mate securely with the connector on the
backplane.
Step 11 Check that the network module LEDs are on. This inspection ensures that connections are secure and that
the new unit is operational.
Initiate a network module session by using the following command:
Step 12
Router# service-module integrated-Service-Engine slot / unit session
Trying 10.10.10.1, 2129 ... Open
SE-Module> enable
SE-Module#
Restore the network module running configuration by using the following command from the service
Step 13
module prompt:
SE-Module# copy tftp: running-config
Address or name or remote host? tftp-server-address
Source filename? filename
Exit the network module session by pressing Control-Shift-6, followed by pressing x.
Step 14
Step 15 On the router, clear the network module session by using the following command:
Router# service-module integrated-Service-Engine slot / unit session clear
Cisco Network Modules Hardware Installation Guide
37-4
Chapter 37
Depending on the specific TFTP server you are using, you might need to create a file with the
same name on the TFTP server and verify that the file has the correct permissions before
transferring the running configuration to the TFTP server.
If the router is not fully configured with network modules, make sure that blank panels fill
the unoccupied chassis slots to provide proper airflow.
Connecting Cisco Unified Messaging Gateway Enhanced Network Modules
OL-2485-20