Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 266

Related Documents
To perform online removal of a CIDS network module and insertion of a replacement, follow these steps
with the router in privileged EXEC mode:
Step 1 Perform a graceful halt of the CIDS network module by using the following command:
Router# service-module IDS-Sensor slot /0 shutdown
Trying 10.10.10.1, 2129 ... Open
Wait for the following status message (it may take a minute or two):
%SERVICEMODULE-5-SHUTDOWN2:Service module IDS-Sensor1/0 shutdown complete
Step 2 Unplug the network interface cable from the CIDS network module.
Loosen the two captive screws holding the CIDS network module in the chassis slot.
Step 3
Slide the CIDS network module out of the slot.
Step 4
Align the replacement CIDS network module with the guides in the chassis slot, and slide it gently into
Step 5
the slot.
Note
Push the module into place until you feel its edge connector mate securely with the connector on the
Step 6
backplane.
Reconnect the network interface cable previously removed in
Step 7
Tighten the two captive screws on the faceplate.
Step 8
Reset the CIDS network module using the reset command.
Step 9
Router# service-module IDS-Sensor slot /0 reset
Use reset only to recover from shutdown or failed state
Warning: May lose date on the hard disc!
Do you want to reset?[confirm]
Press Enter to confirm the request. The CIDS network module resets itself.
Step 10
Check that the network module LEDs are on and that the power and enable LEDs on the front panel also
Step 11
are on. This inspection ensures that connections are secure and that the new unit is operational.
Related Documents
For additional information, refer to the following documents.
For information on obtaining documentation, see the
Tip
For information on obtaining technical assistance, see the
page
Cisco Network Modules Hardware Installation Guide
22-4
If the router is not fully configured with network modules, make sure that blank panels fill the
unoccupied chassis slots to provide proper airflow.
xi.
Chapter 22 Connecting Cisco Intrusion Detection System Network Modules
Step
"Obtaining Documentation" section on page
"Obtaining Technical Assistance" section on
2.
OL-2485-20
viii.