Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 282

Network Analysis Module Overview
Figure 25-1 Cisco Network Analysis Module (NM-NAM) Faceplate and LEDs
NM-NAM
Table 25-1 Cisco Network Analysis Module (NM-NAM) LEDs
Callout
1
2
3
4
5
Connecting Cisco Network Analysis Modules to the Network
To connect a network analysis module to the network, use a straight-through 2-pair Category 5
unshielded twisted-pair (UTP) cable to connect the RJ-45 port on the network analysis module to a
switch, hub, repeater, server, or other network device. (See
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the network analysis module (NM-NAM) only to intrabuilding or nonexposed wiring or cabling.
The intrabuilding cable must be shielded and the shield must be grounded at both ends.
RJ-45 cables are not available from Cisco Systems. These cables are widely available and must be
Note
Category 5 cables.
Cisco Network Modules Hardware Installation Guide
25-2
1 2 3
DISK
Shut down NM-NAM application
before removing or power cycling.
LINK ACT
EN
PWR
FastEthernet 0
4 5
LED Meaning
DISK There is activity on the hard drive.
LINK The Fast Ethernet connection is available to the network module.
ACT There is activity on the Fast Ethernet connection.
PWR Power is available to the network module.
EN The module has passed self-test and is available to the router.
Chapter 25
WARNING!!
Connecting Cisco Network Analysis Modules
CF
Figure 25-2.)
OL-2485-20