Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 286

NAM Enhanced Network Modules
Figure 26-1 NME-NAM-80S Faceplate
f
GRACEFUL <1 s
IMMEDIATE >4 s
CF
SHUTDOWN
LINK
ACT
DISK
SYS
EN
Cisco Network Modules Hardware Installation Guide
26-2
NME-NAM-80S
XXX-XXXXX-XX XX
Never remove compact
SHUTDOWN:
flash during operation
CF
CF
CF card
Shutdown
Status of the CompactFlash
Off—CompactFlash is not used
Flashing—Application detected CompactFlash at boot up
Press the SHUTDOWN button for less than 2 seconds to gracefully shut down the
module. Press the SHUTDOWN button for more than 4 seconds to cause an immediate
module shutdown, which may impact file operations that are in progress.
Status of Gigabit Ethernet link
On—Link is enabled
Off—Link is disabled
Status of Gigabit Ethernet activity
On—Active
Off—Inactive
Status of hard drive activity
On—Active
Off—Inactive
Status of system shutdown
Do not remove power without first shutting down the application.
Note
On—Application is stable.
Off—System is shut down and ready for host power down
Flashing—System shutdown is in progress
Status of the enhanced network module
On—Detected by the host Cisco IOS software and enabled
Off—Disabled
Chapter 26
LINK ACT
DISK SYS
GigE
LINK ACT DISK
SYS
Connecting NAM Enhanced Network Modules
Shut down
application
before removing or
power cycling.
NOT
EN
SUPPORTED
USB
EN
OL-2485-20