Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 80

Ethernet Network Modules
Figure 3-6
ETHERNET
4E
Ethernet AUI cable
(not supplied)
10BASE-T Connections
Use an Ethernet 10BASE-T cable to connect a 10BASE-T port to a hub or other network device. These
ports are color-coded yellow.
connected to a hub.
Figure 3-7
ETHERNET
4E
Cisco Network Modules Hardware Installation Guide
3-4
Connecting an Ethernet AUI Port to a Transceiver
ETH 3 ETH 2
ETH 1
ETH 0
3 2 1
0
LINK
ACT
Ethernet AUI port (DB-15)
(with jackscrews or slide-latch)
BNC connector
To thin Ethernet network
Figure 3-7
Connecting an Ethernet 10BASE-T Port to a Hub
ETH 3
ETH 2 ETH 1
ETH 0
3 2 1
0
LINK
ACT
Ethernet 10BASE-T
port (RJ-45)
10BASE-T cable
Chapter 3 Connecting Ethernet, Fast Ethernet, and Token Ring Network Modules
EN
Ethernet
transceiver
To thin Ethernet network
shows the 10BASE-T port on an Ethernet network module
EN
10BASE-T hub
OL-2485-20