Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 60

Installing Cisco Network Modules in Cisco Access Routers
Proceed with hardware configuration tasks as listed in
Step 5
Removing Slot Dividers
Slot dividers are removed to permit use of double-wide and extended double-wide network modules in
modular router slots. To determine whether you need to install or remove slot dividers on your Cisco
access router, see
To remove slot dividers from network module slots, perform the following steps:
Remove any installed network modules, blank faceplates, and slot adapters from the router slot you plan
Step 1
to use.
Loosen the retention screw on the front of the slot divider.
Step 2
Pull the slot divider straight out of the network module slot.
Step 3
Proceed with hardware configuration tasks as listed in
Step 4
Installing Slot Adapters
Slot adapters (see
module form factors. Slot adapters are used on the following Cisco access routers:
•
•
•
Slot adapters permit installation of extension voice modules (on Cisco 3800 series routers only),
single-wide, and extended single-wide network modules in modular router slots.
To determine whether you need to install or remove slot adapters on your Cisco access router, see
Table 2-3
Cisco Network Modules Hardware Installation Guide
2-12
Table 2-3 and
Figure 2-7) are used to customize network module slots for different Cisco network
Cisco 2821
Cisco 2851
Cisco 3800 series
and Table 2-4.
Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
Table 2-3
Table 2-4.
Table 2-3
and Table 2-4.
and Table 2-4.
OL-2485-20