Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 415

Chapter 40 Cisco Video Management and Storage System Enhanced Network Modules
Shutting Down Cisco Video Management and Storage System Enhanced
Network Modules
Press the SHUTDOWN button on the network module faceplate for less than 2 seconds to perform a
graceful shutdown of the network module before removing power from the router or before starting an
online insertion and removal (OIR) sequence on the router. The application may take up to 2 minutes to
fully shut down.
If you press the SHUTDOWN button for more than 4 seconds, a nongraceful shutdown of the hard disk
Caution
will occur and may corrupt files on the network module's hard disk. After a nongraceful shutdown, the
HD and SYS LEDs remain lit. Press the SHUTDOWN button for less than 2 seconds to gracefully reboot
the network module.
Connecting Cisco Video Management and Storage System
Network Modules
To connect Cisco Video Management and Storage System network modules to an external device, use a
straight-through two-pair Category 5e unshielded twisted-pair (UTP) cable, and connect the RJ-45
Gigabit Ethernet port on the network module to a switch, hub, repeater, server, or other Gigabit Ethernet
network device.
RJ-45 cables are not available from Cisco. These cables are widely available and must be Category 5e
Note
cables.
Connecting to an External Storage Device using iSCSI
The Cisco Video Management and Storage System enhanced network module supports an Internet SCSI
(iSCSI) connection to an external storage device. The Gigabit Ethernet port on the faceplate of the
network module and the Gigabit Ethernet port on the router can be configured as iSCSI connections.
To connect Cisco Video Management and Storage System enhanced network modules to an external
storage device using iSCSI, use a straight-through two-pair Category 5e unshielded twisted-pair (UTP)
cable.
RJ-45 cables are not available from Cisco. These cables are widely available and must be Category 5e
Note
cables.
For details about configuring iSCSI connections, see the TBD (software document) on Cisco.com:
TBD
OL-2485-20
Connecting Cisco Video Management and Storage System Network Modules
Cisco Network Modules Hardware Installation Guide
40-3