Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 411

Chapter 39 Connecting Cisco Analog Video Gateway Network Modules
Align the replacement network module with the guides in the chassis walls or slot divider and slide it
Step 7
gently into the slot. (See
Figure 39-8
ETHE RNET 0
Using the network module handle, push the EVM-IPVS-16A network module into place until you feel
Step 8
the edge connector seat securely into the connector on the router backplane. The network module
faceplate should contact the chassis rear panel.
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the network
Step 9
module faceplate.
Connect the DB-37 to BNC video breakout cable to the VIDEO connector on the EVM-IPVS-16A
Step 10
network module.
Connect the terminal block connector cables to the terminal blocks on the EVM-IPVS-16A network
Step 11
module.
Confirm that the network module LEDs come on. For more information about the LEDs, see the
Step 12
"EVM-IPVS-16A Network Module LEDs" section on page
Initiate a console session with your router.
Step 13
Enter configuration mode, and restart the network module:
Step 14
Router> enable
Router# configure terminal
Router(config)# interface video-Service-Engine
Router(config-if)# no shutdown
Router(config-if)# exit
Router# service-module video-Service-Engine
OL-2485-20
Figure 39-8.)
Installing a Network Module
WO
SERIA L
EVM
IPVS- 16A
20
11
3210
1
How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
39-4.
slot
/0
slot
/0 reset
Cisco Network Modules Hardware Installation Guide
39-11