Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 82

Fast Ethernet Network Modules
Figure 3-9
FAST ETHERNET
1FE
Figure 3-10 1-Port Fast Ethernet Network Module (FX Connector)
FAST ETHERNET
1FE-FX
Fast Ethernet 2-WAN Card Slot Modules
The following 2-slot network modules provide one or two 100BASE-T Fast Ethernet interfaces, plus two
slots for optional WAN interface cards:
•
•
•
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the 1-Fast Ethernet 2-WAN card slot network modules (NM-1FE2W-V2), the 2-Fast Ethernet
2-WAN card slot network modules (NM-2FE2W-V2), and the 1-Fast Ethernet 1-Token Ring 2-WAN
card slot network modules (NM-1FE1R2W-V2) only to intrabuilding or nonexposed wiring or cabling.
The intrabuilding cable must be shielded and the shield must be grounded at both ends.
Cisco Network Modules Hardware Installation Guide
3-6
1-Port Fast Ethernet Network Module (TX Connector)
10/100 bTX
RJ-45 port
1-Fast Ethernet 2-WAN card slot network module (NM-1FE2W and NM-1FE2W-V2). See
Figure 3-11 for a sample faceplate.
2-Fast Ethernet 2-WAN card slot network module (NM-2FE2W and NM-2FE2W-V2). See
Figure 3-12 for a sample faceplate.
1-Fast Ethernet 1-Token Ring 2-WAN card slot network module (NM-1FE1R2W and
NM-1FE1R2W-V2). See Figure 3-13
Chapter 3 Connecting Ethernet, Fast Ethernet, and Token Ring Network Modules
100 b FX
for a sample faceplate.
EN
EN
OL-2485-20