Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 417

Chapter 40 Cisco Video Management and Storage System Enhanced Network Modules
For a description of informational and error messages that may appear on the console during this
procedure, see the hardware installation guide for your router.
To perform online removal of a network module and insertion of a replacement, follow these steps, with
the router in privileged EXEC mode:
Initiate a network module session by using the following command:
Step 1
Router# service-module integrated-Service-Engine slot / unit session
Trying 10.10.10.1, 2065 ... Open
SE-Module> enable
SE-Module#
Save the running configuration of the network module by using the following command from the
Step 2
SE-Module#
SE-Module# copy running-config tftp tftp-server-address filename
Exit the network module session by pressing Control-Shift-6, followed by pressing x.
Step 3
On the router, clear the integrated-Service-Engine console session by using the following command:
Step 4
Router# service-module integrated-Service-Engine slot / unit session clear
Step 5 Perform a graceful shutdown of the network module disk drive by using the following command:
Router# service-module integrated-Service-Engine slot / unit shutdown
Shut down the network module interface:
Step 6
Router (config)# interface integrated-Service-Engine slot/unit
Router (config-if)# shutdown
Router (config-if)# exit
Unplug all network interface cables from the network module.
Step 7
Loosen the two captive screws that are holding the network module in the chassis slot.
Step 8
Slide the network module out of the slot.
Step 9
Align the replacement network module with the guides in the chassis slot, and slide it gently into the slot.
Step 10
Note
Step 11 Push the module into place until you feel its edge connector mate securely with the connector on the
backplane.
Step 12 Reconnect the network interface cables that you removed in
Step 13 Check that the network module LEDs are on. This inspection ensures that connections are secure and that
the new unit is operational.
Step 14 Initiate a network module session by using the following command:
Router# service-module integrated-Service-Engine slot / unit session
Trying 10.10.10.1, 2129 ... Open
SE-Module> enable
SE-Module#
OL-2485-20
prompt:
If the router is not fully configured with network modules, make sure that blank panels fill
the unoccupied chassis slots to provide proper airflow.
Online Insertion and Removal of Cisco Network Modules Procedure
Step 7.
Cisco Network Modules Hardware Installation Guide
40-5