Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 84

Fast Ethernet Network Modules
RJ-45 cables are not available from Cisco Systems. These cables are widely available and must be
Note
Category 5 cables.
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the 1-Fast Ethernet 2-WAN card slot network modules (NM-1FE2W-V2), the 2-Fast Ethernet
2-WAN card slot network modules (NM-2FE2W-V2), and the 1-Fast Ethernet 1-Token Ring 2-WAN
card slot network modules (NM-1FE1R2W-V2) only to intrabuilding or nonexposed wiring or cabling.
The intrabuilding cable must be shielded and the shield must be grounded at both ends.
Figure 3-14 Connecting a Fast Ethernet RJ-45 Port to a Hub
FE–PRI
1FE-1CT 1
Category 5
or UTP cable
100BASE-FX Connections
Attach a multimode fiber-optic cable with SC-type connectors directly to the port on the Fast Ethernet
network module (remove the protective plug from the port if it is present). Use either one duplex SC
connector (see
Figure
correct relationship between the receive (RX) and transmit (TX) ports on the network module and the
cable.
Note Multimode SC-type fiber-optic cables are widely available commercially. Cisco Systems does not
supply these cables.
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the 1-Fast Ethernet 2-WAN card slot network modules (NM-1FE2W-V2), the 2-Fast Ethernet
2-WAN card slot network modules (NM-2FE2W-V2), and the 1-Fast Ethernet 1-Token Ring 2-WAN
card slot network modules (NM-1FE1R2W-V2) only to intra-building or non-exposed wiring or cabling.
The intrabuilding cable must be shielded and the shield must be grounded at both ends.
Cisco Network Modules Hardware Installation Guide
3-8
10/100Base T
CTRLR 0
Fast Ethernet
RJ-45
Figure 3-15 and Figure
3-18). Attach the other end of the cable to a repeater, hub, or wall outlet. Be sure to observe the
Chapter 3 Connecting Ethernet, Fast Ethernet, and Token Ring Network Modules
EN
Fast Ethernet hub
3-17) or two simplex SC connectors (see Figure 3-16 and
OL-2485-20