Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 57

Network modules installation guide
Table of Contents

Advertisement

Chapter 2
Installing Cisco Network Modules in Cisco Access Routers
To prepare a network module slot for a single-wide or extended single-wide network module, perform
the tasks listed in
Table 2-3
Preparing Network Module Slots for Single-Wide and Extended Single-Wide Network Modules
For Single-Wide Network Modules
Step 1
Remove the blank faceplates from the slots you plan to
use. (See the
"Removing Blank Faceplates from Cisco
Access Routers" section on page
Step 2
Remove the slot adapters on the right side of the router
slot. (See the
"Removing Slot Adapters" section on
page
2-14.)
Step 3
Insert the slot divider. (See the
section on page
2-10.)
Step 4
(For single-wide network modules only) Insert the slot
adapter on the right side of the slot you plan to use. (See
the
"Installing Slot Adapters" section on page
Step 5
Install the network module. (See the
Single-Wide, Extended Single-Wide, and Extension
Voice Network Modules in Cisco Access Routers"
section on page
2-15.)
On Cisco 3800 series routers, extension voice modules can be installed in standard network module
Tip
slots. When an extension module is installed in a standard network module slot, treat an extension voice
module like a single-wide network module.
To prepare a network module slot for a double-wide or extended double-wide network module, perform
the tasks listed in
Table 2-4
Preparing Network Module Slots for Double-Wide and Extended Double-Wide Network Modules
For Double-Wide Network Modules
Step 1
Remove blank faceplates from the slots you plan to use.
(See the
"Removing Blank Faceplates from Cisco Access
Routers" section on page
Step 2
Remove the slot adapters on the right side of each router
slot. (See the
"Removing Slot Adapters" section on
page
2-14.)
Step 3
Remove the slot divider. (See the
Dividers" section on page
OL-2485-20
Table
2-3.
2-8.)
"Installing Slot Dividers"
2-12.)
"Installing
Table
2-4.
2-8.)
"Removing Slot
2-12.)
Installing Cisco Network Modules in Cisco Access Routers
For Extended Single-Wide Network Modules
Remove the blank faceplates from the slots you plan to
use. (See the
"Removing Blank Faceplates from Cisco
Access Routers" section on page
Insert the slot divider. (See the
section on page
2-10.)
Install the network module. (See the
Single-Wide, Extended Single-Wide, and Extension
Voice Network Modules in Cisco Access Routers"
section on page
2-15.)
For Extended Double-Wide Network Modules
Remove blank faceplates from the slots you plan to use.
(See the
"Removing Blank Faceplates from Cisco Access
Routers" section on page
2-8.)
Remove the slot adapter on the right side of the
applicable router slot. (See the
Adapters" section on page
Timesaver
If the slot adapter is already installed
against the right side wall of the router
chassis, skip this step.
Remove the slot divider. (See the
Dividers" section on page
Cisco Network Modules Hardware Installation Guide
2-8.)
"Installing Slot Dividers"
"Installing
"Removing Slot
2-14.)
"Removing Slot
2-12.)
2-9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents