Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 296

Connecting 4-Port Serial Interface Network Modules to the Network
Figure 27-4 Connecting the Cisco 12-in-1 Interface Cable to the 4-Port Serial Interface Network Module
NM-CEM-4SER
Using Cisco Extended 12-in-1 Interface Cables with the 4-Port Serial Interface
Network Module (NM-CEM-4SER)
Table 27-4
network module. Use the cable part number to order replacement or spare cables for the interface and
DTE or DCE mode appropriate for your network.
Figure 27-5
Cisco Network Modules Hardware Installation Guide
27-6
(NM-CEM-4SER)
CEM 3
ACT LP
CEM 1
EIA/TIA-232 EIA/TIA-449
Connections at the CPE
lists the Cisco Extended 12-in-1 interface cables supported by the 4-port serial interface
illustrates how to connect the Cisco 12-in-1 cable to the network module.
Chapter 27 Connecting Circuit Emulation Over IP Network Modules
See Manual before installation.
CEM 2
LP ACT
CEM 0
EIA-530
V.35
EIA-530A
EN
AL
X.21
OL-2485-20