Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 73

Network modules installation guide
Table of Contents

Advertisement

Chapter 2
Installing Cisco Network Modules in Cisco Access Routers
Warning
To avoid electric shock, do not insert a WAN or voice interface card into a 2-slot module while power
is on or network cables are connected. Statement 68
Do not perform OIR on interface cards in 1- or 2-slot network modules. To avoid damage to the interface
Caution
card and to the network module, turn off electrical power and disconnect network cables before inserting
an interface card into a network module slot.
Remove all network cables, including telephone cables, from the rear panel of the router.
Step 2
To make it easier to work with network cables, label the cables or prepare a network cabling diagram
Timesaver
before removing network interface cables from the network module.
Using a number 1 Phillips or flat-blade screwdriver, loosen the screws on the blank interface card
Step 3
faceplate. (See
Figure 2-16 Blank Interface Card Faceplate
Save blank interface card faceplates for future use.
Tip
Align the interface card with the guides in the slot on the network module and slide it gently into place
Step 4
until the edge connector is seated into the connector on the module. (See
Figure 2-17 Installing an Interface Card in a Network Module (Typical)
1
Interface card
OL-2485-20
Figure
2-16.) Remove the blank faceplate.
DO NOT INSTALL WAN INTERFACE
CARDS WITH POWER APPLIED
2 E
2 W W 1
E T H 1
B 1
B 2
B R I
S /T
1
Installing Cisco Interface Cards in 1- or 2-Slot Network Modules
Figure
W O
E T H E R
A U I
N E T 0
E N
2
2
2-slot network module
Cisco Network Modules Hardware Installation Guide
2-17.)
2-25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents