Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 327

Chapter 30 Connecting AON Network Modules
To perform online removal of a network module and insertion of a replacement, follow these steps, with
the router in privileged EXEC mode:
Step 1 Initiate a network module session using the following command:
Router# service-module integrated-service-engine slot / unit session
Trying 10.10.10.1, 2065 ... Open
Press RETURN to get started!
Router> enable
Router#
Save the running configuration of the network module using the following command from the
Step 2
router # prompt:
Router# copy running-config tftp tftp-server-address filename
Exit the network module session by pressing Control-Shift-6, followed by x.
Step 3
On the router, clear the integrated-service-engine console session using the following command:
Step 4
Router# service-module integrated-service-engine slot / unit session clear
Perform a graceful shutdown of the network module disk drive by using the following command:
Step 5
Router# service-module integrated-service-engine slot / unit shutdown
Shut down the network module interface:
Step 6
Router (config)# interface integrated-service-engine slot/unit
Router (config-if)# shutdown
Router (config-if)# exit
Step 7 Unplug all network interface cables from the network module.
Loosen the two captive screws holding the network module in the chassis slot.
Step 8
Slide the network module out of the slot.
Step 9
Align the replacement network module with the guides in the chassis slot, and slide it gently into the slot.
Step 10
Note
Push the module into place until you feel its edge connector mate securely with the connector on the
Step 11
backplane.
Reconnect the network interface cables previously removed in
Step 12
Check that the network module LEDs are on and that the power (PWR) and enable (EN) LEDs on the
Step 13
front panel are also on. This inspection ensures that connections are secure and that the new unit is
operational.
Initiate a network module session with the following command:
Step 14
Router# service-module integrated-service-engine slot / unit session
Trying 10.10.10.1, 2129 ... Open
ISE-network module now available
OL-2485-20
If the router is not fully configured with network modules, make sure that blank panels fill
the unoccupied chassis slots to provide proper airflow.
Online Insertion and Removal of Cisco Network Modules
Step 7.
Cisco Network Modules Hardware Installation Guide
30-5