Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 62

Network modules installation guide
Table of Contents

Advertisement

Installing Cisco Network Modules in Cisco Access Routers
Figure 2-9
1
Install other hardware if necessary. (See
Step 3
Orient the slot adapter so the tab on the rear of the slot adapter aligns with the slot on the router
Step 4
backplane.
Note
Slide the slot adapter into the slot.
Step 5
Using a number 1 Phillips or small flat-head screwdriver, tighten the captive screw to secure the slot
Step 6
adapter.
Tip
Proceed with hardware configuration tasks as listed in
Step 7
Removing Slot Adapters
Slot adapters are removed to permit use of double-wide and extended double-wide network modules in
modular router slots. To determine whether you need to install or remove slot adapters on your Cisco
access router, see
Cisco Network Modules Hardware Installation Guide
2-14
Slot Adapter Locations for Double-Wide Network Modules (Generic Router)
Slot adapter
When correctly aligned, the captive screw on the slot adapter aligns with a threaded hole in the
chassis, slot divider, or adjacent slot adapter, depending on your current hardware setup.
The slot adapter can be secured to the router chassis, to a slot divider, or to another slot adapter,
depending on its installation location. See
Table 2-3
and
Chapter 2
Installing Cisco Network Modules in Cisco Access Routers
1
2
Slot adapter
Table 2-3
and
Table
Figure 2-8
Table 2-3
Table
2-4.
2
2-4.)
for possible variations.
and
Table
2-4.
OL-2485-20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents