Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 214

High-Density Analog Telephony Network Module LEDs
Figure 16-5 Label Locations for Expansion Ports
NM-
HDA
High-Density Analog Telephony Network Module LEDs
Figure 16-6
meaning.
Figure 16-6 High-Density Analog Telephony Network Module LEDs
NM-
HDA
Table 16-3 High-Density Analog Telephony Network Module LEDs
LED
EN
ACT
High-Density Analog Voice Card Pinouts
Figure 16-7
Table 16-4
Cisco Network Modules Hardware Installation Guide
16-6
Apply label for EM0 here
Port # Type
1-
4 FXS
4
5-
14
15-
24
Apply label for EM1 here
shows high-density analog telephony network module LEDs.
Port # Type
1-
4 FXS
4
5-
26
14
15-
24
1
Meaning
Green indicates that the module has passed its self-tests and is available to the router.
Green indicates that the module is ready to process data. It goes on when the boot process
is complete and stays on during normal operation.
shows the RJ-21 connector wiring for the cable used for the high-density analog voice card;
lists the pinouts. The port usage depends on the type of expansion cards installed.
Chapter 16 Connecting High-Density Analog Telephony Network Modules
26
1
Active LED
Table 16-3 describes their
50
ACT EN
25
Enable LED
OL-2485-20