Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 55

Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
Table 2-2 Preparing to Install Blank Network Module Faceplates on Cisco Access Router Network Module Slots
On an Extended Single-Wide Slot
Step 1
Install a slot adapter on the right side
of the slot. (See the
Adapters" section on page
Step 2 Install the blank faceplate. (See the
"Installing Blank Faceplates on Cisco
Access Routers" section on
page 2-7.)
Step 3 —
Installing Blank Faceplates on Cisco Access Routers
To install a blank faceplate, perform the following steps:
Determine which type of blank network module faceplate you are using. (See
Step 1
Figure
Figure 2-1
1
1
Figure 2-2
1
1
OL-2485-20
On a Double-Wide Slot
Install a slot divider in the slot. (See
"Installing Slot the "Installing Slot Dividers" section
2-12.) on page
Install a slot adapter in the right side
of the left slot. (See the
Slot Adapters" section on page
Install one blank faceplate over each
slot. (See the
Faceplates on Cisco Access Routers"
section on page
2-2.)
Blank Network Module Panel with Screws
Captive screws for securing blank faceplate
Blank Network Module Panel with Tabs
Snap-lock tab (use screwdriver to remove)
Installing Cisco Network Modules in Cisco Access Routers
2-10.)
"Installing
2-12.)
"Installing Blank
2-7.)
2 Tab
Cisco Network Modules Hardware Installation Guide
On an Extended Double-Wide Slot
Install a slot divider in the slot. (See
the "Installing Slot Dividers" section
on page 2-10.)
Install slot adapters in the right sides
of both slots. (See the "Installing Slot
Adapters" section on page
Install one blank faceplate over each
slot. (See the "Installing Blank
Faceplates on Cisco Access Routers"
section on page 2-7.)
Figure 2-1 and
1
2
2-12.)
2-7