Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 58

Installing Cisco Network Modules in Cisco Access Routers
Table 2-4 Preparing Network Module Slots for Double-Wide and Extended Double-Wide Network Modules (continued)
For Double-Wide Network Modules
Step 4
(For double-wide network modules only) Insert 2 slot
adapters on the right side of the router slot. (See the
"Installing Slot Adapters" section on page
Step 5 Install the network module. (See the
Single-Wide, Extended Single-Wide, and Extension
Voice Network Modules in Cisco Access Routers"
section on page 2-15.)
Installing Slot Dividers
Slot dividers (see
module form factors. Slot dividers are used on the following Cisco access routers:
•
•
•
•
Slot dividers are installed to permit use of extension voice modules (on Cisco 3800 series routers only),
single-wide, and extended single-wide network modules in modular router slots. To determine whether
you need to install or remove slot dividers on your Cisco access router, see
Figure 2-3
To install a slot divider, perform the following steps:
Step 1 Remove any installed network modules, blank faceplates, and slot adapters from the router slot you plan
to use.
Insert the top rails of the slot divider between the two guide rails in the top of the network module slot.
Step 2
(See
Cisco Network Modules Hardware Installation Guide
2-10
2-12.)
"Installing
Figure 2-3) are used to customize network module slots for different Cisco network
Cisco 2851 routers
Cisco 3660 routers
Cisco 3745 routers
Cisco 3800 series
Slot Divider for Network Module Slots (Sample Shows Divider for Cisco 2851 and
3800 Series)
Figure 2-4.)
Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
For Extended Double-Wide Network Modules
Install the network module. (See the
Single-Wide, Extended Single-Wide, and Extension
Voice Network Modules in Cisco Access Routers"
section on page 2-15.)
—
"Installing
Table 2-3 and Table 2-4.
OL-2485-20