Omron SYSMAC CJ - REFERENCE MANUAL 01-2008 Reference Manual page 1221

Other Instructions
Note
Operand Specifications
1182
Data area address
0000CH
0001CH
D00000
D00001
EC_32767
Corresponding
0000CH
data area
0001CH
address
D00000
D00001
E32765
1. If there is no CV-series equivalent to the specified CS/CJ-series PLC mem-
ory address, an error will occur, the Error Flag will be turned ON, and the
address will not be converted.
2. The CV-series PLC memory address data stored by TOCV(285) can be
transferred to a CV-series PLC using CX-Programmer.
3. The same data area address that was used in the CS/CJ-series program
can be specified in the CV-series program by using indirect Index Register
addressing ( ",IR" prefix) or indirect binary mode DM addressing (*DM).
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
EM Area without bank
EM Area with bank
Indirect DM/EM
addresses in binary
Indirect DM/EM
addresses in BCD
Constants
Data Registers
CS/CJ-series PLC memory address
0C000Hex
0C001Hex
10000Hex
Convert
10001Hex
FFFFFHex
CV-series
0000Hex
0001Hex
Convert
2000Hex
2001Hex
FFFDHex
D:
D00100
S
--- CIO 0000 to CIO 6143
--- W000 to W511
--- H000 to H511
--- A448 to A959
--- T0000 to T4095
--- C0000 to C4095
--- D00000 to D32767
--- E00000 to E32767
--- En_00000 to En_32767
(n = 0 to C)
--- @ D00000 to @ D32767
@ E00000 to @ E32767
@ En_00000 to @ En_32767
(n = 0 to C)
--- *D00000 to *D32767
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
See note 1. ---
--- DR0 to DR15
Section 3-31
S
Specify the CS/CJ-series
PLC memory address in S.
(In this case, 10001 hex is
the PLC memory address of
D00001.)
The corresponding CV-series
PLC memory address is
stored in D. (In this case,
data area address D00001 is
converted to PLC memory
address 2001 hex and
stored.)
2001Hex
D