Sony CDP-608ESD Operating Instructions Manual page 74

Guia para la solucion de problemas (Consulte la pagina 76.)
Troubleshooting Guide
Guia para solugao de problemas (vide pagina 77).
Before going through the check list below, first refer back to the connections and operating procedures.
Should any problem persist after you have made these checks, consult your nearest Sony service facility.
i Symptom
The disc tray does not close.
Play does not start.
Cause Remedy
The disc is not placed correctly. Place the disc correctly on the disc tray.
Dirty disc. Clean the disc.
The disc is inserted upside down.
The player is in the pause mode.
Moisture condensation.
insert the disc with the printed side up.
Press EE to release pause.
Leave the player turned on for
approximately one hour.
"DISC/MEMO" is displayed
Play begins only by turning on the power.
There is no disc in the unit.
The TIMER switch is set to PLAY.
Display window does not illuminate even
when the power is turned on.
The DISPLAY ON/OFF button was pressed.
zal
Sound is not heard.
Play does not begin from the first selection.
Loose connection.
Connection is incorrect.
set to the minimum.
The player is in the PROGRAM, or
SHUFFLE or CUSTOM INDEX mode.
The remote commander does not operate
the unit.
—+
The batteries are run down.
The remote commander is not pointed at
There is an obstacle between the remote
commander and the unit.
The remote commander is too far from the
unit.
Any operation is not possible.
74
The internal control program may not run.
'Connecting the CD Player".
The LINE OUT/PHONE LEVEL control is Turn the control clockwise.
the remote sensor.
Insert a disc.
Set the TIMER switch to OFF.
Press the button again.
Insert the plug firmly.
Check the connection refering to
'
+
Press CONTINUE.
Replace both batteries.
Point the remote commander at the sensor.
Remove the obstacie.
Move closer.
Turn off the power and turn it on again.