僅 Distributing The Sealant - Kia Sorento 2023 Manual

What to do in an emergency
cuit damage within the vehicle and the
Tyre Mobility Kit.
7. Make the ENGINE START/STOP but-
ton position on or ignition switch posi-
tion on.
8. Switch on the compressor and let it
run for approximately 5~7 minutes to
fill the sealant up to proper pressure.
(refer to "Tyres and wheels" on page
8-44). The inflation pressure of the
tyre after filling is unimportant and
will be checked/corrected later. Be
careful not to overinflate the tyre and
stay away from the tyre when filling it.
When the tyre and wheel are dam-
aged, do not use Tyre Mobility Kit for
your safety.
WARNING
If the tyre pressure is below
26psi(180kPa), do not drive the vehicle.
The tyre may cause accident.
9. Switch off the compressor.
10.Detach the sealant feeling hoses from
the sealant bottle connector and from
the tyre valve. After using, leave the
sealant bottle and the compressor
attached together.
Return the TMK to its storage location in
the vehicle.
WARNING
Carbon monoxide
Do not leave your vehicle running in a
poorly ventilated area for extended peri-
ods of time. Carbon monoxide poisoning
and suffocation can occur.
If you have a flat tyre (with tyre mobility kit)
Distributing the sealant
OMQ4063014_2
僅 Immediately drive approximately
7~10 km (4~6 miles or, about 10min)
to evenly distribute the sealant in the
tyre.
CAUTION
Do not exceed a speed of 80 km/h (50
mph). If possible, do not fall below a
speed of 20 km/h (12 mph).
Whilst driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of
the side of the road. Call for road side
service or towing.
When you use the Tyre Mobility Kit, the
wheel may be stained by sealant. There-
fore, remove the wheel stained by seal-
ant and have the vehicle inspected at a
professional workshop. Kia recommends
to visit an authorised Kia dealer/service
partner.
Checking the tyre inflation pres-
sure
1. After driving approximately 7~10 km
(4~6 miles or about 10 min), stop at a
safety location.
2. Connect the filling hose of the com-
pressor directly to the tyre valve.
7
7 25