僅 Distributing The Sealant - Kia Soul 2022 Manual

What to do in an emergency
WARNING
Carbon monoxide
Carbon monoxide poisoning and suffo-
cation is possible if the vehicle is left run-
ning in a poorly ventilated or
unventilated location (such as inside a
building).
Distributing the sealant
After putting sealant into the tire, it is
necessary to drive the vehicle so that the
sealant becomes evenly distributed
inside the tire.
ODEEV088017NR
僅 Immediately drive approximately
7~10 km (4~6 miles or about 10 min)
to evenly distribute the sealant in the
tire.
Do not exceed a speed of 80 km/h (50
mph).
While driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of
the side of the road.
If you have a flat tire (with Tire Mobility Kit)
CAUTION
When you use the Tire Mobility Kit, the
tire pressure sensors and wheel may be
stained by sealant. Therefore, remove
the tire pressure sensors and wheel
stained by sealant and have your vehicle
inspected by an authorized Kia dealer.
Checking the tire inflation pres-
sure
After driving briefly so as to distribute
the sealant throughout the inside of the
tire, you should check the tire inflation
pressure.
1. After driving approximately 7~10 km
(4~6 miles or about 10 min), stop at a
safe location.
2. Connect connection hose (10) of the
compressor directly to the tire valve.
OSKEV061016NR
3. Connect between compressor and the
vehicle power outlet using the cable
and connectors.
4. Adjust the tire inflation pressure to the
cold tire recommended pressure as
indicated on the vehicle's placard or
tire inflation pressure label located on
the driver's side center pillar outer
panel. (In this owner's manual, refer to
"Tires and wheels" on page 9-4)
7
7 17