Kia Sorento 2023 Manual page 141

Features of your vehicle
The ignition switch or ENGINE START/
STOP button must be in the ON position
for power windows to operate.
Each door has a power window switch
that controls the door's window. The
driver has a power window lock button
which can block the operation of rear
passenger windows. The power windows
can be operated for approximately 3
minutes after ignition switch or ENGINE
START/STOP button turned to the ACC
or LOCK position. However, if the front
doors are opened, the power windows
cannot be operated even within the 3
minutes period.
The driver's door has a master power
window switch that controls all the win-
dows in the vehicle.
If the window cannot be closed because
it is blocked by objects, remove the
objects and close the window.
NOTICE
Whilst driving with the rear windows
down or with the sunroof (if equipped) in
an open (or partially open position), your
vehicle may demonstrate a wind buffet-
ing or pulsation noise. This noise is a
normal occurrence and can be reduced
or eliminated by taking the following
actions. If the noise occurs with one or
both of the rear windows down, partially
lower both front windows approximately
one inch. If you experience the noise
with the sunroof open, slightly reduce
the size of the sunroof opening.
WARNING
Do not install any accessories in the area
of windows. It may impact jam protec-
tion.
Window opening and closing
You can open and close windows using
the power window switch.
Type A
OMQ4033037
To open or close a window, press down
or pull up the front portion of the corre-
sponding switch to the first detent posi-
tion (5).
Type B - Auto up/down window
(if equipped)
OMQ4033036
Pressing or pulling up the power window
switch momentarily to the second detent
position (6) completely lowers or raises
the window even when the switch is
released. To stop the window at the
desired position whilst the window is in
operation, pull up or press down and
release the switch.
To reset the power windows
If the power window does not operate
normally, the automatic power window
system must be reset as follows:
1. Turn the ignition switch or ENGINE
START/STOP button to the ON posi-
tion.
Windows
4
4 49