僅 Replacing Stop And Tail Lamp (Bulb Type) - Kia Sorento 2023 Manual

Maintenance
Replacing side repeater lamp
(LED type)
OMQ4073057
If the Side repeater lamp (LED) (1) does
not operate, have your vehicle checked
by a professional workshop.
Kia recommends to visit an authorised
Kia dealer/service partner.
The LED lamp cannot be replaced as a
single unit because it is an integrated
unit. The LED lamp has to be replaced
with the unit.
A skilled technician should check or
repair the Side repeater lamp (LED), for
it may damage related parts of the vehi-
cle.
Replacing stop and tail lamp
(Bulb type)
OMQ4073085
1. Turn off vehicle and disconnect the
negative terminal from the battery.
2. Open the tailgate.
3. Open the service cover.
4. Loosen the light assembly retaining
screws with a cross-tip screw driver.
8 68
OMQ4073086
5. Remove the rear combination lamp
assembly from the body of the vehi-
cle.
6. Disconnect the rear combination lamp
connector.
7. Remove the socket from the assembly
by turning the socket counterclock-
wise until the tabs on the socket align
with the slots on the assembly.
OMQ4073087
8. Remove the bulb from the socket by
pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket.
Pull the bulb out of the socket.
9. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
10.Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
11.Install the rear combination lamp
assembly to the body of the vehicle.
12.Install the service cover.
Light bulbs