僅 Distributing The Sealant - Kia EV9 2024 Manual

What to do in an emergency
Distributing the sealant
After putting sealant in the tire, it is nec -
essary to drive the vehicle so that the
sealant becomes evenly distributed
inside the tire.
OMV063009_2
僅 Immediately drive approximately 4~6
miles (7~10 km or, about 10 minutes)
to evenly distribute the sealant in the
tire.
Do not exceed a speed of 80 km/h (50
mph). If possible, do not drop below 20
km/h (12 mph).
While driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed further and
drive with caution until you can safely
pull off of the side of the road.
CAUTION
When you use the TMK, the tire pressure
sensors and wheel may be stained by
sealant. Remove the tire pressure sen -
sors and wheel stained by the sealant
and have your vehicle inspected by an
authorized Kia dealer.
If you have a flat tire (with Tire Mobility Kit)
Checking the tire inflation pres -
sure
After driving briefly so as to distribute
the sealant in the tire, check the inflation
pressure.
1. After driving approximately 4~6 miles
(7~10 km or about 10 minutes), stop
at a safe location.
2. Connect the compressor and the tire
connection hose directly to the tire
valve.
OMV063008
3. Connect the 12V battery connector/
cable to a 12V battery.
4. To increase the tire pressure, turn on
the compressor and adjust the pres -
sure to the specified tire pressure.
5. To decrease the tire pressure, turn the
tire pressure adjustment knob to
adjust to the appropriate tire pres -
sure.
6. To check the current tire pressure,
temporarily turn off the compressor
僅 To increase the inflation pres -
sure, switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
NOTICE
The pressure gauge may show higher
than actual reading when the compres -
sor is running. To get an accurate tire
reading, the compressor needs to be
turned off.
8
8 17