Panasonic Switch-M12PWR Operation Manual page 55

Available commands are listed below.
E Set Enable/Disable of access limitation via Telnet.
E Set access limitation from Telnet to Enable.
D Set access limitation from Telnet to Disable.
A Set an IP address to be permitted. Five ranges can be set up.
Press "A." The command prompt changes to "Enter IP address entry number>."
Enter an IP address entry number between 1 and 5. The command prompt
changes to "Enter IP address>." Enter an IP address to be permitted. If IP address
is correct, the command prompt changes to "Enter subnetwork mask>." Enter a
range of IP address you wish to permit accessing with subnet mask format.
(Setting example)
No. IP Address
--- -------------
1 192.168.1.10
2 192.168.1.20
3 192.168.2.1
4 192.168.3.1
D Delete a range of IP address that has been set up.
Press "D." The command prompt changes to "Enter IP address entry number>."
Enter an IP address entry number you wish to delete.
M Change a range of IP address that has been set up.
Press "M." The command prompt changes to "Enter IP address entry number>."
Enter an IP address entry number between 1 and 5. The command prompt
changes to "Enter IP address>." Enter an IP address that has been set up. The
command prompt changes to "Enter subnetwork mask>." Enter a range of IP
address you wish to permit accessing with mask.
Q Return to the previous menu.
Subnet Mask
----------------
255.255.255.255 192.168.1.10
(Only one unit can be accessed)
255.255.255.254 192.168.1.20, 192.168.1.21
(Two units can be accessed)
255.255.255.128 192.168.2.1 – 192.168.2.127
(127 units can be accessed)
255.255.255.0 192.168.3.1 – 192.168.3.254
(254 units can be accessed)
55
Access permitted IP Address
-----------------------------