Panasonic Switch-M12PWR Operation Manual page 32

Screen Description
System up for Displays the cumulative time since the power on of this Switching Hub.
Boot / Displays this Switching Hub's firmware version.
Runtime Code The left side displays the Boot Code and the right side displays the
Version Runtime Code.
("TFTP Software Upgrade" in 4.9.1 is about Runtime Code update.)
Hardware Displays the hardware information.
Information
Version
CPU
Utilization
DRAM / Flash
Size
DRAM User
Area Size
System
Temperature
Administration Items shown here are configured in accordance with "4.6.1 System
Information Administration Configuration."
Switch Name
Switch
Location
Switch
Contact
System Items shown here are configured in accordance with "4.6.2 System IP
Address Configuration."
Information
MAC Address
IP Address
Subnet Mask
Default
Gateway
DHCP Mode:
Displays the hardware version information.
Displays the CPU utilization.
Displays the sizes of installed DRAM and FLASH
memory.
Displays the sizes of the user area memory and unused
memory.
Displays the internal temperatures of the Switching
Hub.
The sensors measure the temperature of CPU and
system.
Displays the Switching Hub name. The factory default
setting is blank. For configuration details, refer to 4.6.1.
Displays the Switching Hub's location. The factory
default setting is blank. For configuration details, refer
to 4.6.1.
Displays the contact information. The factory default
setting is blank. For configuration details, refer to 4.6.1.
Displays the MAC address of this Switching Hub. This
value is uniquely assigned to each device and cannot be
changed.
Displays the Switching Hub's current IP address. 0.0.0.0
is the factory default setting. For configuration details,
refer to 4.6.2.
Displays the Switching Hub's current subnet mask.
0.0.0.0 is the factory default setting. For configuration
details, refer to 4.6.2.
Displays the IP address of the router for the default
gateway. 0.0.0.0 is the factory default setting. For
configuration details, refer to 4.6.2.
Displays whether to get an IP address using DHCP. For
configuration details, refer to 4.6.2.
32