Table of Contents
Advertisement
Available commands are listed below.
S
Set the SNMP manager status.
Press "S." The command prompt changes to "Enter manager entry number>." Enter
an SNMP manager entry number you wish to configure. Then, the command
prompt changes to "Enable or Disable SNMP manger (E/D)>." Press "E" to enable
the SNMP manager. Press "D" to disable it.
I
Set an IP address for an SNMP manager.
Press "I." The command prompt changes to "Enter manager entry number>." Enter
an SNMP Management entry number you wish to configure. Then, the command
prompt changes to "Enter IP address for manager>." Enter an IP address.
R
Set access privileges for an SNMP manager.
Press "R." The command prompt changes to "Enter manager entry number>." Enter
an SNMP manager entry number you wish to configure. Then, the command
prompt changes to "Enter the selection>."
Press "1" for read-only permission. Press "2" for read-and-write.
C
Set a community name for an SNMP manager.
Press "C." The command prompt changes to "Enter manager entry number>." Enter
an SNMP manager entry number you wish to configure. Then, the command
prompt changes to "Enter community name for manager>." Enter a community
name.
Q
Return to the previous menu.
40
Advertisement
Table of Contents
