Panasonic Switch-M12PWR Operation Manual page 53

Available commands are listed below.
C Configure the idle timeout settings for automatically terminating a
console-connected session if no input is made.
Press "C." The command prompt changes to "Enter console idle timeout>." Enter a
value from 0 to 60 (minutes). Entering "0" disables the automatic termination.
T Configure the idle timeout settings for automatically terminating a Telnet-connected
session if no input is made.
Press "T." The command prompt changes to "Enter telnet idle timeout>." Enter a
value from 1 to 60 (minutes).
N Edit the login username.
Press "N." The command prompt changes to "Enter current password>." Enter the
current password. After entering the correct password, the command prompt
changes to "Enter new name>." Enter a new username in 12 characters.
P Edit the login password.
Press "P." The command prompt changes to "Enter old password>." Enter the
current password. After entering the correct password, the command prompt
changes to "Enter new password>." Enter a new password in 12 characters. After
entering the password, the command prompt changes to "Retype new
password>" for confirmation. Enter the new password again.
L Configure the Telnet access settings.
Press "L." The command prompt changes to "Enable or Disable telnet
server(E/D)>."
Enter "E" to enable the access. Enter "D" to disable the access.
S Configure the SNMP access settings.
Press "S." The command prompt changes to "Enable or Disable SNMP
Agent(E/D)>."
Enter "E" to enable the access. Enter "D" to disable the access.
W Configure the web access settings.
Press "W." The command prompt changes to "Enable or Disable web
server(E/D)>."
Enter "E" to enable the access. Enter "D" to disable the access.
Y Configure the settings for sending system logs to the Syslog server.
Press "Y." The command prompt changes to "Enable or Disable Syslog
Transmission (E/D)>."
Enter "E" to enable the Syslog transmission to the Syslog server. Enter "D" to
disable the Syslog transmission to the Syslog server.
R Configure the access settings to access the RADIUS server. The RADIUS used in the
IEEE802.1X port-based authentication.
Press "R" to move to the RADIUS Configuration page. For configuration details,
refer to the next section (4.6.5.a).
G Configure the settings for sending system logs to the Syslog server.
Press "G" to move to the Syslog Transmission Configuration page. For
configuration details, refer to the next section (4.6.6.b).
Q Return to the previous menu.
53